OUTPUT

DC Voltage

24 V

Rated current

2.5 A

Current range

0 ~ 2.5 A

Rated power

Ripple & Noise (max.) Note 2

150 mVp-p

Voltage Adj. range

21.6 ~ 26.4 V

Voltage tollerance Note 3

± 1.0%

Line regulation

Load regulation

Setup, rise time

100 ms, 30ms/230VAC; 200ms,30ms/115VAC at full load

Hold up time (Tip.)

100 ms/230VAC; 23ms/115VAC at full load

INPUT

Voltage Range

88 ~ 264 VAC ; 124 ~ 370 VDC

Frequency range

47 ~ 63 Hz

Efficiency (Typ.)

84%

Tensione AC (Typ.)

1.2 A / 115VAC ; 0.8 A / 230 VAC

Inrush current (Typ.)

 cold start 18 A / 115VAC ; 36 A / 230 VAC

PROTECTION

Overload

105 ~ 160% rated output power;
Protection type: constant current limiting, recovers automatically after fault condition is removed

Overvoltage

27.6 ~ 32.4V Prot. Tipo: Protection Type: Shut down o/p voltage, re-power on to recover

ENVIRONMENT

Working temp.

-20 ~ +60°C (Ref. Derating curve)

Working humidity

20 ~ 90% RH non – condensing

Storage temp. humidity      

-40 ~ +85°C , 10~95% RH non – condensing

Temp. coefficient

±0.03%/°(0~50°C) RH non – condensing

Vibration

10~500Hz, 2G 10min./1cycle, period for 60 min. each long axes x,y,z

Mounting

Compliance to IEC60068-2-6

SAFETY & EMC  NotE 4

Safety standards

UL60950-1, TUV EN60950-1 approved; design refer to EN50178

Withstand voltage

I/P-0/P:3KVAC

Isolation resistance

I/P-O/P: 100M Ohms / 500VDC /25 °C / 70% RH

EMC emission

Compliance to EN55011, EN55022 (CISPR22), Classe B, EN61000-3-2-3, -3.

EMC immunity

Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, EN61000-6-2, EN61204-3, heavy industry level, criteria A

OTHERS

MTBF

215.2K HRS min. MIL-HDBK-217F (25°C)

DIMENSIONS

78*93*56mm (W*H*D)

PACKING

0.3 Kg; 48pcs/15.4Kg/1.02CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1 uf & 47 uf parallel capacitor.

3. Tolerance: includes set up tolerance, line regulation, and load regulation.

4. The power supply is considered a component that will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.